LG DLEC733W Owner's Manual

uirement For E c D
hnportant : Grounding _hrough the neutral conductor
is prohibited tbr (1) new branch_ircuit installations,
(2) mobile homes,, and (3):recreational veNcles,, and
(4) areas where local codes prohibit grounding fllrough
the neural conductor.
Prepare minimmn 5fi (1.52m) of length in order for
dryer to be :replaced..
First, strip 5 inches (12.7cm)of outer sheath from
end and strip 1 inch of insulation from each
conductor.
Then, put tile hooked shaN end of the wire under the
screw of fl_eternfinal block (hooked end facing
rightward) and pinch the hook together and screw tightly.
• if your Mcal codes or ordfllmlces do not allow file
use of a 3 wire connection, or you are installing
your dryer in a mobile home, you must use a 4-
wire connection.
plug
3/4 in. (1.9 _l .
ULapprovedstrainrelief
1. Comlect neutral wire (white) of power cord to
center terminal block screw.
2. Comlect red mid black wire to the left mid right
terminal block screws.
3. Make sure lhat lhe strain relief screw is lightened
and be sure that all terminal block nuts are on
tight and power cord is ill right position.
Cen_ t_inal
_k _ {silver)
_ _our_ing
wi_ (wN_)
Ne_I g_an_
F_xterr_g_nd
_r
Direc>wire connections do not meet the
building code regulations in most areas, !t is
the customer's responsibility to ensure that the
I:_'or_ Ringterminals
--Neutral
.
.
(_ nnect neutral wire (white) of power cord to
center terminal block screw.
C_ nnect :redand black wire to the left and right
terminal block screws.
3. Connect ground wire (green) of power cord m
external ground screw and move neutral ground
wire of appliance and connect :itm cenmr screw.
4. Make sure that the strain relief screw is tightened
and be sure that all terminal block nuts arc on
tight and power cord is in right position.

LG DLEC733W Specifications

General

Brand	LG
Model	DLEC733W
Category	Dryer
Language	English