6. Reverse the hinge and the hinge bracket at the bottom of the cabinet.
Remove the two screws from the hinge bracket at bottom right and
remove the hinge bracket.
Remove the lower of the two screws behind the hinge bracket.
Do NOT remove the upper screw behind the hinge bracket.
Set the parts aside.
7. Remove the three screws on the hinge at bottom left.
Remove the hinge and reinstall it on the right side.
The top screw occupies the hole where you removed the screw
behind the hinge bracket in step 6.
8. Install the hinge bracket removed in step 6 on the bottom left side,
9. With the door laid inside facing up on a protected surface, remove the
Φ5 screw
10. Remove the four screws on the door
cover that secure The door strike and
the blank cover.
Switch the door strike and the blank
cover, installing them on the opposite
sides from which they were removed.
Set the door cover aside.
Long screw Short screw
Cap
upper
hinge
hinge
cover
latch hole
cover
latch
mechanism
hinge
bracket
hinge
To Next Page
Loading...
