TROUBLESHOOTING37
Before calling for service (conf.)
I
Problem
Clothes take too
long to dry
CHECK FILTER light
is on during the
drying cycle
FLOW SENSETM
indicator shows four
bars during the drying
cycle
. Load is not properly sorted.
. Large load of heavy fabrics.
. Dryer controls are not set properly.
. Lint filter needs to be cleaned.
° Exhaust ducts blocked, dirty, or duct run is
too Iong.v
° House fuse is blown, circuit breaker has
tripped, or power outage has occurred.
° Dryer is overloaded.
° Dryer is underloaded.
. Separate heavy items from lightweight items. Larger and heavier items take
longer to dry.
. Heavy fabrics take longer to dry because they tend to retain more moisture.
To help reduce and maintain more consistent drying times for large and heavy
fabrics, separate these items into smaller loads of a consistent size.
. Use the appropriate control settings for the type of load you are drying.
. Make sure the lint filter is cleaned before every load. With some loads that produce
high amounts of lint, it may be necessary to clean the filter during the cycle.
. Confirm that the exhaust ductwork is properly configured and free of debris,
lint, and obstructions. Make sure that outside wall dampers can open properly
and are not blocked,jammed, or damaged.
. Reset circuit breaker or replace fuse. Do not increase fuse capacity. If the
problem is a circuit overload, have it corrected by a qualified electrician.
. Divide larger loads into smaller loads for drying.
. If you are drying a very small load, add a few extra items to ensure proper
tumbling action.
Clothes are shrinking . Garment care instructions are not being . To avoid shrinkage, please carefully follow the fabric care instructions for
followed, your garment, because some fabrics will naturally shrink when washed. Other
fabrics can be washed but will shrink when dried in a dryer. Use a low or no
heat setting.
Garments still wrinkled . Too many or too different types of garments . Small loads of 1 to 5 items work best.
after Steam Fresh TM in dryer. . Load fewer garments. Load similar-type garments.
There are no creases . The function of this cycle is to remove . Use an iron to make creases.
left on garment after wrinkles from fabric.
Steam Fresh TM
Odors remain in clothing . STEAM FRESW _did not remove odor . Fabrics containing strong odors should be washed in a normal cycle.
after STEAM FRESW'_ completely.
• Lint filter is almost clogged or full. • Pause the drying cycle and clean the lint filter.
. Install a shorter or straighter duct run. See the Installation Instructions.
The display shows
"d90","d95"
° Ductwork is too long or has too many turns/
restrictions.
° Significant blockage of the ductwork due to
lint buildup or debris.
.The appliance has detected a restriction in
the external dryer venting.
.The duct work is about 90%-95% blocked.
Cd90"or"d95"error code displayed 2 hours
only)
. House exhaust system blocked.
° Ductwork should be checked/cleaned soon.
Dryer can be used in this condition, but drying times may be longer.
TM
° If exhaust restrictions are sensed by the FLOW SENSE system, the indicator
will remain on for two hours after the end of the cycle. Opening the door or
pressing the POWER button will turn offthe display.
. Do not use the dryer until the exhaust system has been cleaned and/or
repaired. Using the dryer with a severely restricted exhaust is dangerous and
could result in a fire or other property damage.
. Check the outside dryer vent while the dryer isoperating to make sure there is
strong airflow.
. If the exhaust system is extremely long, have it repaired or rerouted.
. Keep the area around the dryer clean and free of clutter.
. Check vent hood for damage or lint clogging.
. Make sure the area around the vent hood is clear.
To Next Page
