22
PROGRAMMING MODE
Coin Box Key
- coin type -
- card type - - OPL type -
Insert Debit Card
How to enter "Programming mode"
You can enter programming mode only for Idle state and
pause state.
- Card Type
1) Insert service card.
2) Display will show “ ”
- Coin Type
1) Dissemble upper coin box key.
2) Take out the coin drop from the coin box.
3) Turn on/off the toggle switch at the back of the coin box.
4) Display will show “ ”.
- OPL Type
1) Push the WHITES & DELICATES button at the same time.
2) Push the COLORS button 3 times.
3) Push the START button.
4) Display will show “ ”.
How to use button
You can change Washer vend price, cycle time and Cycle
parameters, etc.
: You can check machine information or change setting on “Program setup”, “Collect Information Data”, ”Diagnostic Test”.
PROGRAMMING MODE
Coin Vault
Openings : close
Press Button Description
WHITES
Move to upper level or
Comes back to Idle State
COLORS Move to the mode in the same level (+)
DELICATES Move to the modes in the same level (-)
START Enter the selected mode
NOTE
• If you turn on the power without connecting meter case for the first time, the machine display “ ”.
• When the machine is came out from the factory, it is set in the coin type. You can change Card/Coin type by button.
(For more information refer to SETUP mode.)
• The machine will display “PUSH” for OPL type.
• Do not enter the "Vend type set up" mode if the machine is a coin type. You cannot restore it back to Coin type without a
special card reader and a service card after it has been changed to Card type in the set up mode.
To Next Page
Loading...
Need help?
General
