51
PROGRAMMING MODE - SETUP MODE
NOTE
• This function is only controlled in machine.
(It is not applied in setup card.)
Entering set up mode.
You will see LqC1
Button Display
Press the
WHITES
button.
Press the
COLORS
or the
DELICATES
button until appears in the display.
Press the
START
button.
Press the
COLORS
or the
DELICATES
button until appears in the display.
Press the
START
button.
Press
COLORS(+)
or
DELICATES(-)
button and then select
or
23.7 [KHz] 23.5 [KHz]
One or the other will
display.
Press the
START
button.
The machine sets up the value of water level, then advances to the next process
automatically.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready mode.
• Coin type - Turn on/off toggle switch.
• Card type - Pull the service card.
• OPL type - Push the WHITES button twice.
22. How to change the water level
You can change the water level by selecting two options.
1. LO indicate water level 23.7 [KHz]
2. HI indicate water level 23.5 [KHz]
To Next Page
Loading...
Need help?
General
