Washer does not
start.
Washer will not spin.
Door does not open.
Wash cycle time
delayed.
Fabric softener
overflow.
Softeners dispensed
too early.
• Electrical power cord may not
be plugged in or connection
may be loose.
• House fuse blown, circuit
breaker tripped,or a power
outage has occurred.
• Water supply tap is not turned
on.
•
Check that the door is firmly
shut.
Too much softener may cause
an overflow.
Make sure plug fits tightly in wall
outlet.
Reset circuit breaker or replace
fuse. Do not increase fuse capacity.
If problem is a circuit overload, have
it corrected by a qualified electrician.
Turn on water supply tap.
Close the door and press the
Start/Pause button. After pressing
the Start/Pause button, it may take
a few moments before the clothes
washer begins to spin. The door
must lock before spin can be
achieved.
Add 1 or 2 similar items to help
balance the load.
Rearrange load to allow proper
spinning.
Once machine has started, the door
cannot be opened for safety
reasons. Check if the “Door Lock”
icon is illuminated. You can safely
open the door after the “Door Lock”
icon turns off.
The washing time may vary by the
amount of laundry, water
pressure, water temperature and
other usage conditions.
If the imbalance is detected or if the
suds removing program works, the
wash time shall be increased.
Follow softener guidelines to ensure
appropriate amount is used.
Do not exceed the maximum fill line.
Close the dispenser drawer slowly.
Do not open the drawer during the
wash cycle.
Symptom Possible Cause Solution
31
roubleshooting guide
T
To Next Page
Loading...
Need help?
General
