How to enter Programming mode
You can enter programming mode only for Idle
state and pause state.
- Card Type
1) Insert service card.
2) Display will show .
- Coin Type
1) Dissemble upper coin box key.
2) Take out the coin drop from the coin box.
3) Turn on/off the toggle switch at the back of
the coin box.
4) Display will show .
- All Types
1) Push the Hot & Cold button at the same
time.
2) Push the Warm button 3 times.
3) Push the Start button.
4) Display will show .
How to use button
You can change Washer vend price, cycle time
and Cycle parameters, etc.
: You can check machine information or change setting on Program setup, collect information data,
Diagnostic test. There are two methods that you can enter programming mode.
PROGRAMMING MODE
Coin Box Key
- Coin type -
- Card type - - OPL type -
Insert Debit Card
Coin Vault
Openings close
Press
Button
Description
Hot
Moves to upper level or
Comes back to Idle State
Warm
Moves through modes in the same
level (+)
Cold
Moves through modes in the same
level (-)
Start
Enters the selected mode
NOTE
• If you turn on the power without connecting meter case for the first time, the machine display
.
• When the machine is shipped from the factory, it is set in the coin type. You can change Card/
Coin type by button. (For more information refer to SETUP mode.)
• The machine will display PUSH for OPL type.
• Price setting varies by country
• Set your country from
mode (Refer
How to enter the
)
• After EEPT, reset your country (Default country is EUK)
To Next Page
Loading...
Need help?
General
