LG Flatron 795FT Plus (FB795E-UA) - Page 10

- 10 -
4. TOTAL CHASSIS ASSEMBLY REMOVAL
1) Disconnector the CDT Earth Pin(a).
2) Remove four screws (a).
3) Disconnect P901 (Degaussing pin), P701 (DY pin), P451, P453 from the Main PCB.
4) Disconnect P301, P302, P303 from the Video PCB.
5) Remove the DY Assembly Screw (c).
6) Carefully separate the CDT Board Assembly from the CDT neck.
7) Discharge the remaining static electricity by shorting between the Anode Cap and the CDT ground.
8) Disconnect the Anode Cap from the CDT.
9) Remove the Total Chassis Assembly from the Main PCB Ass’y and Video PCB Ass’y.
DY-Pin
P901
P451
P302
P303
P301
Degaussing
Coil
(b)
(b)
(b)
(b)
(a)
(a)
(c)
(d)
P453
P702
P701
P401
Anode Cap
DY Assembly Screw