To Next PageTo Next Page
Need help?Do you have a question about the LG FLATRON F700B and is the answer not in the manual?
General| Screen Size | 17 inches |
|---|---|
| Display Type | CRT |
| Maximum Resolution | 1280 x 1024 |
| Refresh Rate | 85 Hz |
| Aspect Ratio | 5:4 |
| Viewable Size | 16 inches |
| Dot Pitch | 0.25 mm |
| Vertical Refresh Rate | 50 - 160 Hz |
| Bandwidth | 110 MHz |
| Horizontal Refresh Rate | 30 - 70 kHz |
| Input Signal | VGA |
Input voltage levels and sync polarity for signals.
Voltage levels, impedance, color, and format for video input.
Details of the signal connector type.
Horizontal and vertical scanning frequency ranges.
AC input voltage range and current.
Power consumption in different operating modes.
Dimensions of the active video display area.
Color capabilities and supported display resolutions.
Maximum video bandwidth supported.
Recommended operating temperature and humidity ranges.
Maximum operating altitude.
Importance of using specified parts for safety.
Checks to perform before servicing equipment.
Precautions regarding electrical hazards during service.
Care during installation to avoid CRT implosion.
Measures to prevent X-radiation from the picture tube.
How to turn the monitor on and off.
Meaning of the power indicator light colors.
How to enter and exit the on-screen display.
Using buttons for adjusting settings.
How to select options in the on-screen display.
Circuit for suppressing noise on the power input line.
Circuit for degaussing the CRT screen.
Operation of the Switching Mode Power Supply.
How the system prevents X-radiation.
Function of the microprocessor and its associated circuits.
Circuit generating horizontal and vertical pulses.
DC voltage supply for horizontal deflection.
Circuit for correcting screen distortion.
Circuit for horizontal deflection of the screen.
Generating high voltage for the CRT.
Correcting horizontal linearity.
Circuit for vertical deflection.
Circuit for maintaining focus on screen.
Blanking and brightness control functions.
Correcting screen tilt using a tilt coil.
Amplifying the analog video signal.
Amplifying video signal for CRT cathode.
Procedure to check B+ voltage levels.
Steps to adjust the high voltage output.
Adjusting factory preset modes.
Adjusting color balance and brightness.
Fine-tuning color balance and brightness.
Procedure for inputting EDID data.
Steps to adjust the monitor's focus.
Steps to diagnose and resolve power-on problems.
Troubleshooting steps for a blank screen.
Diagnosing issues with no visible raster.
Troubleshooting a single vertical line.
Diagnosing and fixing H-linearity issues.
Troubleshooting no vertical deflection.
Diagnosing issues with the On-Screen Display.
Troubleshooting issues with power management modes.
Steps to resolve degaussing failures.
Troubleshooting tilt and rotation control problems.
Pin details for the M24C08 serial I2C BUS EEPROM.
Pin configuration for the TDA4867J IC.
Pin details for the TDA4841PS IC.
Component placement on the control board.
Solder side view of the control board.
Component placement on the main board.
Solder side view of the main board.
