- 11 -
DESCRIPTION OF BLOCK DIAGRAM
1. Input signal switching part.
There are two inputs which are analog and digital analog input.
They come from each 15 pin D-Sub and 24 pin DVI-I connector.
2. Video Controller Part.
This part amplifies the level of video signal for the digital conversion and converts from the analog video signal to the
digital video signal using a pixelclock.
The pixel clock for each mode is generated by the PLL.
The range of the pixel clock is from 25MHz to 135MHz.
This part consists of the Scaler, Flash-ROM IC which stores program data,Reset IC.
The Scaler gets the video signal converted analog to digital, interpolates input to1280 X 1024 resolution signal and
outputs R, G, B signal to transmitter.
The controlled data of each modes and user setting is stored in EEPROM
Especially Micom/pre-amp / ADC / Video controller are merged to one chip ‘Gm5120’ by Genesis. .
3. Display Data Transmitter Part.
This part transmit digital signal from the Scaler to the receiver of module.
4. Power Part.
This part consists of the one 5V, two 3.3V and one 2.5 regulators to convert power which is provided 12V, 5V in
LIPS Board.
5V is provided for LCD Panel.
Also, 5V is converted 3.3V and 2.5V by regulator. Converted power is provided for IC in the main board.
To Next Page
Loading...
Need help?
General