Figure 1. Cable Connection
SVC OSD
1) Turn off the power switch at the front side of the display.
2) Wait for about 5 seconds and press MENU, PR+ and VOL+ with in 1 second interval.
3) The SVC OSD menu contains additional menus that the User OSD menu as described below.
a) ELAP. TIME CLEAR: Displays or clears the used time.
b) AUTO GAIN/OFFSET: Automatically sets the gain and offset value. (Pattern is used for D-Sub
window pattern.)
c) AUSTRALIA TV: The default value is off. When watching the Australian TV, turn it on.
d) R/G/B-GAIN: Allows you to set the R/G/B gain value manually.
e) R/G/B-OFFSET: Allows you to set the R/G/B-OFFSET value manually.
f) FAN: The default value is set to Auto. If set to Auto, the fan runs according to the surrounding
temperature. If set to On, the fan will run indefinitely as long as the power is on. (You can use this
option to check fan operation status. Make sure to set to Auto after inspection.)
g) TXT LANG: Set the proper text language (0~16).
h) RESET: The default value is set to Off. You can change the setting only after setting on after SVC
OSD menu change.
To Next Page
Loading...
