LG FMN0760NL - The Indoor Unit Installation

- 35 -
3. The Indoor Unit Installation
(1) Room Type Indoor Unit
The mounting wall should be strong and solid
enough to protect it from the vibration.
1. Mount the installation plate on the wall with
four Type "A" screws.
(If mounting the unit on the concrete wall, consid-
er using anchor bolts.)
• Always mount the Installation plate horizontally
by aligning the marking-off line by means of the
thread and a level.
2. Drill the piping hole with 70mm dia. holecore
drill.
• Line according to the arrows marked on lower
the left and the rght side of the Installation Plate.
The meeting point of the extended line is the
center of the hole.
• Drill the piping hole at either the right or the left
and the hole should be slightly slant to the out-
door side.
Installation Plate
marking-off line
Thread
Weight
Type "A" screw
5~7mm
Indoor Outdoor
Wall
ø70mm
ø70mm
50mm
20mm
20mm
80mm
Left rear piping Right rear piping
FMN0760NL, FMN0960NL
FMN1260NL
ø70mm ø70mm
A
A
A
A
Left rear piping Right rear piping
FMN1860NL
Left rear piping Right rear piping
Hole Center
ø70mm
"D"
"C"
The lower left and the right side of
Installation Plate