Wall
5~7mm
Indoor Outdoor
Set screw of
cardboard (4 pieces)
Cardboard
for installation
Ceiling board
150mm
Adjust the same height
Ceiling board
Ceiling
Flat washer for M10
(accessory)
Keep the length of the bolt
from the bracket to 40mm
Open the ceiling board
along the outer edge of the
paper model
Flat washer for M10
(accessory)
Hanging bolt
(W3/8 or M10)
Nut
(W3/8 or M10)
Nut
(W3/8 or M10)
Spring washer
(M10)
Air Conditioner body
Ceiling
board
Cassette trim
Air
Cool air leakage
(no good)
Bad example
Air conditioner unit
Air conditioner
unit
Cassette trim
Fit the insulator (this part) and
be careful for cool air leakage
Good example
Ceiling
board
• The following parts are local purchasing.
Hanging Bolt - W 3/8 or M10
Nut - W 3/8 or M10
Spring Washer - M10
Plate Washer - M10
• Drill the piping hole on the wall slightly tilted to the
outdoor side using a Ø 70 hole-core drill.
• Tighten the nut and bolt to prevent the unit from
falling off.
CAUTION
• Install certainly the cassette trim.
• Cool air leakage causes sweating. Water drops fall.
CAUTION
To Next Page
Loading...