- 58 -
LGE Internal Use Only Copyright © 2009 LG Electronics. Inc. All right reserved.
Only for training and service purposes
3. TECHNICAL BRIEF
Copyright © 2007 LG Electronics. Inc. All right reserved.
Only for training and service purposes
LGE Internal Use Only
Figure 3.12.4 Different Application Scenarios
In order to achieve the single-speaker concept by parallel connection of Earpiece and Headset amplifier the
Earpiece amplifier have to sustain the up to 5 V voltage of the class-D amplifier.
Audio-in Path
The audio-in path of X-GOLD™213 provides two differential microphone input sources, MIC1and MIC2.
• The inputs for microphone MIC1 are MICP1 and MICN1.
• The inputs for microphone MIC2 are MICP2 and MICN2.
The selection between MIC1 and MIC2 can be done with AFE_AUDIOINCTRL.
MICINSEL. The audio-in path consists of an input selector, a low noise amplifier and following pre-filter with gain
control, a second order ΣΔ-converter and a digital decimation filter. It supports both standard GSM (bandwidth
3.5 kHz) and wideband
(bandwidth 7 kHz) speech bands.
The differential input signal from the microphone first passes a low noise amplifier and following pre-filter and
an anti-aliasing pre-filtering stage achieving and overall variable gain ranging from 0 dB to +39 dB . The signal is
then modulated by a second order ΣΔ-converter which is clocked with the same clock rate as the digital to
analog converters. The ΣΔ-converter delivers a 1-bit pulse density modulated data stream at a rate of 2 MHz to
the digital decimation filter which reduces the rate to 8 kHz or 16 kHz, depending on the current mode.
To improve SNR the sample frequency can be doubled in dedicated modes and the modulated data stream is
4MHz instead of 2 MHz.
To Next Page
Loading...
