INSTALLATION
4
Installing on a firm and flat surface
- Unstable installation is the main reason of
vibration and noise.
- when the refrigerator is installed unstably, it can
be stabilized by adjusting the adjustable foot.
- Slightly rising the front part of the refrigerator
allow you to close the door very easily.
- When installed on a carpet or floor,please put a
firm mat under the refrigerator otherwise the
bottom part will change colour.
• Keep an appropriate distance between the wall
- To ensure proper air circulation around the
fridge-freezer, please maintain sufficient space on
both the sides as well as top and maintain at least
2 inches (5 cm) from the rear wall.
- A smaller gap will restrict the operation of the
refrigerator, which may result in an increase in
power.
• Installing in a less humid environment
- Do not install the refrigerator in a humid place or
where water can easily be splashed.
- If the refrigerator is installed in a humid
environment,it will go moldy. This will lower
insulation property and cause electricity leakage
• Avoid installing near heat and gas
- High temperature will lower the refrigeration
and increase the power consumption.
- Installing near gas or smoke will change the
surface colour of the refrigerator.
To Next Page
Loading...
Need help?
General
