Power On
Waiting 3 minutes
Press the SW01C for
5 seconds.
is displayed.
Start auto-addressing setup.
Indoor unit address number is displayed on the cable
remote control.
It is not an error message, and will disappear
when on/off button is pressed on remote control.
e.g.) CH01, CH02, CH03 etc.
•Finish auto-addressing setup.
•The number of the connected indoor
units whose auto-addressing is
completed is displayed for 30 seconds
on the 7-segment LED after
completing the setup.
Waiting about 2~7 minutes
No
Check the connections
of transmission cable
Yes
Completed
Turn all the dip switches OFF on the outdoor unit main
board before auto-addressing setup.
To Next Page
Loading...
