LG GHP SUPER - Page 55

ELECTRICAL WIRING
ENGLISH
55
DIP Switch Setup
The number is sequentially appeared on the 7-segment. (The farthest dip switch from the 7-seg-
ment is granted the first number 1. )
Check the settings after the dip switch setup
- After the dip switch setup, turn ON the outdoor unit power then you can check the setting val-
ues of the outdoor unit on the 7-segment LED.
- The display will last only 2 seconds after applying the power.
- It checks whether the input is properly performed without the bad contact of the dip switch.
CAUTION
Improper setup of the dip switch will cause a malfunction of the unit.
!
Main board
For the master ODU
For the slave ODU (if there is only one ODU, only apply the settings to the master ODU).
7-segmentDip switch
SW02C(X: cancel)
SW03C(ȯ: next)
SW04C(ȭ: previous)
SW01C(Ɨ: operation and
auto-addressing setup)
SW01D(reset)
DIP switch settings Remark
Factory settings Nor-
mal mode
DIP switch settings Remark
The slave outdoor unit
must be configured.