LG KP175 - Factory Reset [MENU 4]; Eng Mode [MENU 5]; Call Timer; Band Selection

LGE Internal Use Only Copyright © 2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
- 108 -
10. ENGINEERING MODE
10.4 Factory Reset [MENU 4]
This Factory Reset menu is to format data block in the flash memory and this procedure set up the
default value in data block.
Attention
1 Fact. Reset (i.e.Factory Reset) should be only used during the Manufacturing process.
2 Servicemen should NOT progress this menu, otherwise some of valuable data such as Setting
value, RF Calibration data, etc. cannot be restored again.
10.5 Eng Mode [MENU 5]
Engineering mode is designed to allow a service man/engineer to view and test the basic functions
provided by a handset.
10.5.1 Call Timer
This displays total conversation time. This value is never reset even after Factory Reset.
10.5.2 Band Selection
This menu is designed to allow a service man/engineer to select band and test.
10.5.3 Battery info
1) TEMP Cal : This displays the value of Temperature Calibration. The following menus are displayed
in order : TEMP_HIGH_LIMIT, TEMP_HIGH_RECHARGE_LMT, TEMP_LOW_RECHARGE_LMT,
TEMP_LOW_LIMIT
2) Bat Cal : This displays the value of Battery Calibration. The following menus are displayed in order :
BAT_LEV_4V, BAT_LEV_3_LIMIT, BAT_LEV_2_LIMIT, BAT_LEV_1_LIMIT, BAT_IDLE_LI MIT,
BAT_INCALL_LIMIT, SHUT_DOWN_VOLTAGE, BAT_RECHARGE_LMT
3) MVBAT ADC : This displays Battery voltage ADC.
4) AUX ADC : This displays AUX ADC.
5) TEMPER ADC : This displays temperature ADC.