LGE Internal Use Only
Copyright © 2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
- 116 -
1. Connect as Fig 6-2(RS232 serial cable is connected between COM port of PC and MON port of
TEST JIG, in general)
2. Set the Power Supply 4.0V
3. Set the 3
rd
, 4
th
of DIP SW ON state always
4. Press the Phone power key, if the Remote ON is used, 1
st
ON state
12.4 Procedure
1. Connect as Fig 12.2.2 (RS232 serial cable is connected between COM port of PC and MON port of
TEST JIG, in general.)
2. Run Hot_Kimchi.exe to start calibration.
3. From the Calibration menu, Select KP175!
12. AUTO CALIBRATION
To Next Page
Loading...
