LGE Internal Use Only
Copyright © 2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
- 121 -
12. AUTO CALIBRATION
1. Connect as Fig 6-2(RS232 serial cable is connected between COM port of PC and MON port of
TEST JIG, in general)
2. Set the Power Supply 4.0V
3. Set the 3
rd
, 4
th
of DIP SW ON state always
4. Press the Phone power key, if the Remote ON is used, 1st ON state
12.4 Procedure
1. Connect as Fig 12.2.2 (RS232 serial cable is connected between COM port of PC and MON port of
TEST JIG, in general.)
2. Run Hot_Kimchi.exe to start calibration.
3. From the Calibration menu, Select KP265!
To Next Page
Loading...
