LG KP260 - ELT Mode [MENU 2]; Version [MENU 3]; Factory Reset [MENU 4]; Eng Mode [MENU 5]

LGE Internal Use Only Copyright © 2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
- 113 -
10. ENGINEERING MODE
10.1.8 MicRcv
The sound from MIC is recorded for about 3 seconds, then it is replayed on the speaker automatically.
10.1.9 KeyPad
When a pop-up message shows ‘Press Any Key’, you may press any keys including side keys,
but not [Soft2 Key]. If the key is working properly, name of the key is displayed on the screen.
Test will be completed in 15 seconds automatically.
10.2 ELT Mode [MENU 2]
10.2.1 Automatic
10.2.2 Manual
10.3 Version [MENU 3]
This displays software version stored in the phone.
10.4 Factory Reset [MENU 4]
This Factory Reset menu is to format data block in the flash memory and this procedure set up the
default value in data block.
Attention
1 Fact. Reset (i.e.Factory Reset) should be only used during the Manufacturing process.
2 Servicemen should NOT progress this menu, otherwise some of valuable data such as Setting
value, RF Calibration data, etc. cannot be restored again.
10.5 Eng Mode [MENU 5]
Engineering mode is designed to allow a service man/engineer to view and test the basic
functions provided by a handset.
10.5.1 Call Timer
This displays total conversation time. This value is never reset even after Factory Reset.
10.5.2 Band Selection
This menu is designed to allow a service man/engineer to select band and test.