Installing the USIM
card and battery
1. Installing the USIM card.
Your USIM card contains
your phone number, service
details and contacts and
must be inserted into your
handset. If your USIM card is
removed then your handset
becomes unusable (except for
emergency calls depending
on which Country you are in
at the time) until a valid one is
inserted. Always disconnect the
charger and other accessories
from your handset before
inserting and removing your
USIM card. Slide the USIM card
into the USIM card holder.
Make sure that the USIM card
is properly inserted and the
gold contact area on the card is
facing downwards.
To remove the USIM card, press
down lightly and pull it in the
reverse direction.
To insert the USIM card
To remove the USIM ca
d
Note
v
The metal contact of the USIM
card can easily be damaged by
scratches. Pay special attention
to the USIM card while handling.
Follow the instructions supplied
with the USIM card.
2. Installing the battery.
Insert the battery into the
battery compartment as the
metal contacts meet in the
middle of the phone.
Push down the top of the
battery until it snaps into place.
Place the battery cover to the
phone as shown.
3. To remove the battery.
Turn the phone up-side down,
as shown, gently push down
the battery cover to release and
lift off. Then lift up the battery
with your fingers and pull-out
the battery.
GETTING STARTED
GETTING STARTED
KS20 Open UK_축(합본용)_011613 13 2008.1.16 11:52:8 AM
To Next Page
Loading...
