35
Part 15.19 statement
This device complies with part 15 of FCC
rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference. (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
Part 15.21 statement
Change or Modifications that are not expressly
approved by the manufacturer could void the
user’s authority to operate the equipment.
Part 15.105 statement
This equipment has been tested and found
to comply with the limits for a class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. if this equipment
does cause harmful interference or television
reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
FCC RF Exposure Information
WARNING!
Read this information before operating the
phone.
In August 1996, the Federal Communications
Commission (FCC) of the United States, with
its action in Report and Order FCC 96-326,
adopted an updated safety standard for
human exposure to Radio Frequency (RF)
electromagnetic energy emitted by FCC
regulated transmitters. Those guidelines
are consistent with the safety standard
previously set by both U.S. and international
standards bodies. The design of this phone
complies with the FCC guidelines and these
international standards.
Body-worn Operation
This device was tested for typical body-worn
operations with the back of the phone kept
0.39inches (1cm) between the user’s body
and the back of the phone. To comply with
FCC RF exposure requirements, a minimum
separation distance of 0.39 inches (1cm) must
be maintained between the user’s body and
the back of the phone. Third-party belt-clips,
To Next Page
Loading...
