Why does my LG LD-2040WH Dishwasher display a DRAIN ERROR?
A DRAIN ERROR on your LG Dishwasher typically indicates a problem with the draining process. This can be due to a clogged filter (clean the filter), a kinked or blocked drain hose (remove the cause of the kink or block), or a problem with the drain pump/motor or its circuit (replace the drain pump/motor or repair the circuit).
What to do if my LG Dishwasher shows an INLET ERROR?
An INLET ERROR on your LG Dishwasher suggests a problem with the water supply. First, ensure the water tap is fully opened. Check the inlet hose for any kinks and repair if necessary. Also, the filter of the inlet valve may be clogged by impure water: close the water tap, unscrew the inlet hose (inlet valve side), and clean the filter. The inlet water valve itself may be faulty and need replacement or repair. Low water pressure (below 0.5 kgf/) can also trigger this error, so check the water level. Finally, the inlet valve may be blocked by a safety device for leakage sensing; in this case, disconnect the inlet hose to the dishwasher to unlock the safety valve.
What to do if my LG LD-2040WH Dishwasher displays a LEAKAGE ERROR?
If your LG Dishwasher is showing a LEAKAGE ERROR, it means that water is leaking. Check the hose connections and replace them if necessary. Also inspect for any damages that may be causing water to leak and repair or replace the related parts.
What does EXCESS ERROR mean on my LG LD-2040WH Dishwasher and how to fix it?
An EXCESS ERROR on your LG Dishwasher indicates a problem with water filling. This could be due to a troubled inlet valve (replace the inlet valve), a faulty air break (replace the air breaker), a problematic sensor assembly (replace the sensor assembly), or a controller issue (repair or replace the controller).
Why does my LG Dishwasher display a HEATER ERROR?
A HEATER ERROR on your LG Dishwasher indicates a problem with the heating system. This can be due to a troubled heater circuit (repair the heater circuit), a faulty thermistor (replace the thermistor), a shorted heater (replace the heater), or a problem with the relay circuit (repair the relay circuit).
Service information is for experienced individuals; risks of injury or property damage exist.
Lists error codes, their possible causes, and recommended remedies for common issues.
Troubleshooting flowcharts for common operational problems like no power or unsatisfactory washing results.
Specifies dimensions, clearances, and preparation steps for the dishwasher's installation location.
Outlines safety warnings and requirements for electrical hookup, including grounding and circuit protection.
General| Rated Voltage / Frequency | AC 220V/50Hz |
|---|---|
| Rated Power(Watt) | 2, 180 |
| Heater Power(Watt) | 2, 070 |
| Power Consumption (kWh) | 1.05 (Economy) |
| Auto-Off Power Switch | Yes |
| Installation | Free Standing / Built-In |
| Door Colour | White / Silver |
| Place Settings | 12 |
| Control | Electronic |
| Programs | 6 |
| Operating Time (min) | 86(Except Drying):Economy |
| Fan Dry System | Yes |
| Delay Start Function | Yes |
| Process Monitor | Yes |
| Wash Level | 5 |
| Tub Material | Stainless Steel |
| Upper Rack Position | Adjustable |
| Lower Rack | 50% Fold down |
| Racks | Nylon Coating |
| Water Consumption(ℓ) | 16 (Economy) |
| Operating Water Pressure (Bar) | 0.5 ~ 8 |
Weight and Dimensions| Product Dimension(mm) | 600(W)× 600(D)× 850(H) |
|---|---|
| Product Weight(Kg) | 52 |
To Next Page
