22 HOW TO USE
HOW TO USE
Before Use
Clean the refrigerator.
Clean your refrigerator thoroughly and wipe off all dust that accumulated during shipping.
CAUTION
Do not scratch the refrigerator with a sharp object or use a detergent that contains alcohol, a flam-
mable liquid or an abrasive when removing any tape or adhesive from the refrigerator,.
Do not peel off the model or serial number label or the technical information on the rear surface of the
refrigerator.
.@ NOTE
Remove adhesive residue by wiping it off with your thumb or dish detergent.
Connect the power supply.
Check if the power supply is connected before use.
Read the "Turning On The Power" section.
Turn off the icemaker if the refrigerator is not yet connected to the water supply.
Turn off the automatic icemaker and then plug the power plug of the refrigerator into the grounded electric
outlet.
* This is applicable only to certain models.
--z_CAUTION
Runningthe automaticicemakerbeforeconnectingitto thewater supplymay cause the refrigeratorto
malfunction.
Wait for the refrigerator to cool.
Allow your refrigerator to run for at least two to three hours before putting food in it. Check the flow of cold
air in the freezer compartment to ensure proper cooling.
--Z_CAUTION
Puttingfood inthe refrigeratorbeforeithas cooledcouldcause thefood to spoil,ora bad odorcould
remain inside the refrigerator.
The refrigerator makes a loud noise after initial operation.
This is normal. The loudness will decrease as the temperature lowers.
Open refrigerator doors and freezer drawers to ventilate the interior.
The inside of the refrigerator may smell like plastic at first. Remove any adhesive tape from inside the refrig-
erator and open the refrigerator doors and the freezer drawers for ventilation.
To Next Page
Loading...
