INSTALLATION 11
Removing/Assembling the
Refrigerator Door Handles
Removing/Assembling the
Freezer Drawer Handle
NOTE
Removing the doors is always recommended when it /
is necessary to move the refrigerator through a nar-
/
row opening. If it is necessary to remove the handles,
follow the directions below.
Removing the Handles
1 Loosen the set screws D with a s/ in. Allen wrench and
32
remove the handle.
Loosen the mounting fasteners _ that connect to the
refrigerator door and handle using a 1/4 in. Allen wrench,
remove the mounting fasteners.
Assembling the Handles
Assemble the mounting fasteners El at both ends of the
handle using a 1/4in. Allen wrench.
Place the handle on the door by fitting the handle foot-
prints over the mounting fasteners and tightening the set
screws _ with a a/a2in. Allen wrench.
Removing the Handles
1 Loosen the set screws _ located on the lower side of
the handle with a 1/8in. Allen wrench and remove the
handle.
Loosen the mounting fasteners _ that connect to the
freezer drawer and handle using a 1/4 in. Allen wrench,
and remove the mounting fasteners.
Assembling the Handles
Assemble the mounting fasteners _ at both ends of the
handle using a 1/4in. Allen wrench.
Place the handle on the door by fitting the handle foot-
prints over the mounting fasteners and tightening the set
screws _ with a 1/sin. Allen wrench.
To Next Page
Loading...
