LG LFXS29766 Series - ICEMAKER (Freezer Room) OPERATING METHOD and TROUBLE SHOOTING

- 97 -
13. ICE MAKER (Freezer Room) OPERATING METHOD AND TROUBLE SHOOTING
13-1 Working Principles
14-1-1 Ice Maker Working Principles
Power Input
Initial Control
Ice Making
Control
Ice Ejection
Control
Water Supply
Control
Test Control
· Level Ice Maker Cube Mould for “Initial Control”
after power is input.
·Wait until the water in the cube mould is frozen
after ice maker starts operation.
·Checkicebucketisfulloficebyrotatingiceejection
 motorinnormalandreversedirectionandejecticeinto
the ice bucket if ice bucket is not full.
· Conduct “Ice Making Control” after supplying water into the ice maker
cube mould by operating water valve.
· This is for refrigerator assembly line and service. When “ice making test
switch” is pressed, it operates in the following steps: initial iceejection
 water supply control steps.
1. Turning the Icemaker stop switch off (O) stops the Icemaking function.
2. Setting the Icemaker switch to OFF and then turning it back on will reset the Icemaker control.
Power
Switch
Automatic
Shut off Arm