REMOTE CONTROL 31
ENGLISH
Registering Magic Remote
Control
It is necessary to
‘
pair
’
(register) the magic
remote control to your TV before it will work.
How to register the Magic
remote control
How to use Magic Remote
Control
1
2
If the pointer disappears, move
the remote control slightly to left
or right. Then, it will automatically
appear on the screen.
»If the pointer has not been
used for a certain period
of time, it will disappear.
You can move the pointer by
aiming the Pointer Receiver of
the remote control at your TV
then move it left, right, up or
down.
»If the pointer does not work
properly, leave the remote
control for 10 seconds then use
it again.
1
2
To register automatically,
turn the TV on and press the
(Wheel) button. When
registration is completed,
the completion message
appears on the screen.
If registration fails, turn the
TV off and back on, then
press the Wheel(OK) button
to complete registration.
How to re-register the Magic
remote control
Precautions to Take when
Using the Magic Remote
Control
BACK
HOME
1
2
Press and hold the
BACK and HOME
buttons together for 5
seconds to reset, then
register it by following
“
How
to register the Magic remote
control
”
above.
To re-register the Magic
remote control, press and
hold the (BACK) button
for 5 seconds toward the
TV. When registration is
completed, the completion
message appears on the
screen.
•
•
•
•
•
•
Use the remote control within the maximum
communication distance (10 m). Using the
remote control beyond this distance, or
with an object obstructing it, may cause a
communication failure.
A communication failure may occur due to
nearby devices. Electrical devices such as
a microwave oven or wireless LAN product
may cause interference, as these use the
same bandwidth (2.4 GHz) as the Magic
Remote Control.
The Magic Remote Control may be damaged
or may malfunction if it is dropped or
receives a heavy impact.
Take care not to bump into nearby furniture
or other people when using the Magic
Remote Control.
Manufacturer and installer cannot provide
service related to human safety as the
applicable wireless device has possibility of
electric wave interference.
It is recommended that an Access Point (AP)
be located more than 1 m away from the
TV. If the AP is installed closer than 1 m, the
magic remote control may not perform as
expected due to frequency interference.
To Next Page
Loading...
Need help?
General
