12
USING THE CONTROLS
H OW TO U S E
Under normal operation, the exhaust fan cycles
on and off with the compressor, and the
circulation fan runs at the set
speed.
The ENERGY SAVER mode helps
reduce power consumption by
automatically turning off the
circulation fan as well as the exhaust fan when
the compressor is off. The air conditioner will
automatically cycle both fans on and off with the
compressor as needed for cooling.
ENERGY SAVER
To turn the AUTO CLEAN function on, press the
AUTO CLEAN button while the air conditioner is
running in COOL or DRY mode.
This function can only be
selected from the control panel;
it is not available from the
remote. It must be set each time
you wish to run the AUTO CLEAN function.
AUTO CLEAN is used to remove moisture from the
heat exchange coils. This helps prevent the
formation of mildew and odors.
To use AUTO CLEAN:
With the air conditioner running in COOL or
DRY mode, press the AUTO CLEAN button.
The indicator will light.
Press the POWER button to turn the air
conditioner off. AUTO CLEAN will run
the circulation and exhaust fans with the
compressor off for a few minutes after
the power is turned off.
To cancel AUTO CLEAN, or to stop an
AUTO CLEAN cycle in process, simply press
the AUTO CLEAN button again. The AUTO CLEAN
function will not operate if the air conditioner is
already off.
AUTO CLEAN
1
2
AUTO SWING function can only be activated with
the remote. When this function is on, the air
discharge will oscillate to
circulate air more evenly
through the room. To turn this
function off, simply press the
AUTO SWING button with the
remote again. This setting will stay in memory,
even if the power is turned off.
With AUTO SWING off, you may also manually
adjust the air discharge to the desired position.
It will maintain this position until the air
conditioner is turned off or AUTO SWING
is activated.
AUTO SWING
Power
Temp
Fan Speed
Timer Mode
Energy
Saver
Auto
Swing
To Next Page
Loading...
