LG LP 1200DXR - Installation in Vertical Sliding Windows

16
I N S TA L L AT I O N I N S T RU C T I O N S
Foam seal A
(Adhesive type)
Foam seal C
(Adhesive type-shorter)
Sellante de espuma A
(Tipo adhesivo)
Tipo C de sellado con espuma
(tipo adhesivo-más corto).
Joints en Mousse A
(Adhesive type)
Joints en Mousse C
(Plus court de type adhésif)
INSTALLATION IN VERTICAL SLIDING WINDOWS
NOTE: The window installation kit can be used with vertical sliding windows between 18"
and 36"wide.
1
Cut the foam seal A(adhesive type) &
C(adhesive type-shorter) to the proper
length, and attach it to the window sash and
frame.
2
Insert the vent panel assembly, including
extension panels, if needed, into the window
opening. Make sure the rain shield is to the
outside and sloping down. Extend the
extension panels, if used.
Foam seal B
(Non-adhesive type)
Sellado con espuma B
(tipo no adhesivo)
Joints en Mousse B
(Non adhésif)
4
Cut the foam seal B(Non-adhesive type) to
the window width. Stuff the foam seal B
between the glass and the window to
prevent air and insects from getting into the
room.
3
Carefully lower the window. Secure the vent
panel in place with 4 type B screws, plus
one screw for each extension:
Vent panel only: 4 type B screws
Vent panel and
one extension: 5 type B screws
Vent panel and
two extensions: 6 type B screws
Type B screws
Extension panel
(if required)
Vent
Panel
Rain shield