LG LP1017WSR User Manual

ENGLISH
11
one-degree
one-hour increments.
runs the compressor until
cycles the compressor
SLEEP mode can be used with any of the four modes.
This function gives you a more comfortable environment
for sleep.
The appliance will stop operation automatically after
operating for 8 hours.
The fan speed is automatically set to Low.
This function can only be activated from the remote.
Sets the air discharge louvers to open and shut,
circulating the air more effectively through the room.
This function can only be set from the remote.
If the louvers do not move properly, unplug and plug in
the power cord.
LED display shows the set temperature, fan speed, or
the selected TIMER delay.
LEDs illuminate to indicate the active Mode, fan speed,
and other settings. An E5 error code displays when the
water drain tank needs to be emptied.
If you use the Heat mode, you must install the drain
hose. (See pages 21-22 for more information.) If only
the Cool mode is used, the drain hose is not needed.
DRAIN PUMP (Optional)
COV34636802 2018. 4. 23. 오후 5:11 페이지 11

LG LP1017WSR Specifications

General

Type	portable
Color	white
Operating Area Size	300.3 square feet
Cooling Settings	2
Seasonally Adjusted Cooling Capacity	6500 british thermal units
Heater	no
Fan Speeds	2
Fan Airflow Rate	220.0 cubic feet per minute
Hose	single
Noise Level	53 decibels adjusted
Remote Control	yes
Wireless Connectivity	none
Timer	yes
Sleeping Mode	no
Control Type	touchpad
Voltage	115
Current	11.3 amperes
Depth	12.8 inches
Height	27.4 inches
Width	16.9 inches
Net Weight	59.52 pounds