LG LP1017WSR User Manual

22
INSTALLATION INSTRUCTIONS
HEATING DRAINAGE (Optional)
If you use the Heat mode, you must install the drain hose. If only the Cool mode is used,
the drain hose is not needed.
If the outside temperature is at or near freezing (32°F/0°C) follow the indoor drainage instruc-
tions.
If using the outdoor drainage method, make sure the outlet of the hose is aimed away from
nearby surfaces that could be stained or damaged by the draining water.
INDOOR DRAINAGE
1. To attach the drain hose, insert the connector into the upper drain port at the back of the unit
until it snaps into place.
2. Place the other end of the drain hose in a bucket that holds at least 28 ounces. Remember to
check and empty the bucket frequently to avoid overflows.
3. Set the unit to automatic drain by pressing the Fan and Down buttons at the same time.
4. To detach the drain hose, push the outer ring of the upper drain port in and pull the connector
out.
COV34636802 2018. 4. 23. 오후 5:11 페이지 22

LG LP1017WSR Specifications

General

Type	portable
Color	white
Operating Area Size	300.3 square feet
Cooling Settings	2
Seasonally Adjusted Cooling Capacity	6500 british thermal units
Heater	no
Fan Speeds	2
Fan Airflow Rate	220.0 cubic feet per minute
Hose	single
Noise Level	53 decibels adjusted
Remote Control	yes
Wireless Connectivity	none
Timer	yes
Sleeping Mode	no
Control Type	touchpad
Voltage	115
Current	11.3 amperes
Depth	12.8 inches
Height	27.4 inches
Width	16.9 inches
Net Weight	59.52 pounds