Operation of functions is the same when using the
remote or the control panel, unless otherwise stated.
The remote and the control panel are not in sync.
For best results when using the remote, remember
to check that all desired settings are correct on the
remote as well as on the control panel.
NOTE:
The remote sensor is located on the front panel of
the air conditioner. Point the remote from anywhere
at the sensor.
The remote may not work if the sensor is in bright
light or if there is not a clear path between the
remote and the sensor.
Some functions may not be supported, depending
on the model.
Turns the air conditioner on and off.
A chime sounds to confirm you have turned it on or off.
Press this button repeatedly to toggle through and select
the operating mode. Modes include Cool, Dry (dehumidi-
fy), Fan, and Heat. An LED illuminates to indicate the
selected mode. The default mode is Cool. See the
Operation section for more information.
NOTE: Press and hold the Mode button on the remote for
3 seconds to switch the temperature display from degrees
Celsius (°C) to degrees Fahrenheit (°F).
Press repeatedly to toggle the fan speed between High
and Low settings. An LED illuminates to indicate the
selected fan speed. The fan speed can be changed in the
Cool, Fan, and Heat modes. The fan speed is preset in the
Dry mode. After pressing the button, there is a brief delay
before the fan motor changes speed.
Use the timer function to set the air conditioner to turn on
or off at a desired time. The timer function can only be set
using the remote. See the Operation section for more
information.
COV34636802 2018. 4. 23. 오후 5:11 페이지 10
To Next Page
Loading...
Need help?
General
