12
HOW TO USE
OPERATION
MODES
COOL
Compressor runs and cools the room. Use the
Ʒ/Ƹ
and FAN buttons to set the desired temperature and
fan speed. The desired temperature can be set from
60°F to 86°F (16°C to 30°C) in one-degree
increments.
FAN
Fan circulates air but compressor does not run. Use
the FAN button to set the desired fan speed to either
High or Low.
DRY
Use the Dry mode to remove humidity from the room
without additional cooling. This mode adjusts the
room temperature and the fan speed automatically to
maintain the optimal level of humidity.
RESTARTING THE AIR CONDITIONER
AUTOMATICALLY
When the air conditioner is turned on again after a
power failure, this function restores the previous
Settings.
TIMER
Use the Timer function to turn the air conditioner
ON/OFF automatically.
Setting the Air Conditioner to Turn ON
1. Plug in the air conditioner and power it ON.
2. Set the desired mode, temperature, fan speed, etc.
3. Power OFF the air conditioner.
4. Press Timer and use the
Ʒ/Ƹ
buttons to set the
desired delay time until the air conditioner turns
ON. The delay time can be set from 0 to 24 hours
in one-hour increments.
5. The Timer LED on the air conditioner illuminates,
and the delay time appears on the remote and in
the control panel.
6. To cancel the Timer function, press Timer twice.
Setting the Air Conditioner to Turn OFF
1. Plug in the air conditioner and power it ON.
2. Set the desired mode, temperature, fan speed, etc.
3. Press Timer and use the
Ʒ/Ƹ
buttons to set the
desired delay time until the air conditioner turns
OFF. The delay time can be set from 0 to 24 hours
in one-hour increments.
4. The Timer LED on the air conditioner illuminates,
and the delay time appears on the remote. The
delay time appears briefly in the control panel and
is then replaced by the set temperature.
5. To cancel the Timer function, press Timer twice.
NOTE: To check the remaining time, press Timer.
COV34636801 2017. 12. 11. 오전 10:09 페이지 12
To Next Page
Loading...
Need help?
General
