Service Bulletin
Product :
Bulletin # :
Release Date :
1. Symptoms and Causes
a) Symptoms
- There are abnormal vibration and noise.
b) Causes
- When lower balance weight was fell out, it makes abnormal vibration and noise.
• The information is available through “https://gsfsplus-america.lge.com” with a valid ID.
• The information is intended for experienced technicians, not for customers .
• The information is subject to change or update without notice.
Front Loader
<Repair information>
DFZ201800040
2. Repair Instruction
- Change the part. (Lower balance weight)
Step 1) Remove the origin part
Step 2) Assemble the new part fully
Step 3) Tighten bolts follow the order (Refer to the below picture)
Step 4) After change the part, check the ‘A’ dimension every points(4 points)
Refer to below picture.
1st 2nd
3rd
4th
Gap A
• If the ‘A’ is bigger than 0.08inch(2mm), it is OK.
• If the ‘A’ is smaller than 0.08inch(2mm), it is NG.
You have to tighten the bolt more than now.
April 16th, 2018
Gap A
Gap A
To Next Page
Loading...
Need help?
General
