Freezer
Compartment
Lamp
Dispenser Lamp
Freezer
Compartment
Shelf
Door Rack and
Suppo_
Ice Storage Bin
After Dispenser
Is Used
How to Dismantle Parts
Separatethe lamp by pullingit out ® while
slightlystriking(1)and rotating @the lampcover.
Turnthe bulbcounterclockwise,Max,40 W bulb
for refrigerator isused and can be purchased at
a servicecenter.
Seperate the lamp by pulling it out, and then
remove the lamp. Max. 15 W bulb for
refrigerator is used and can be purchased at a
service center.
To remove a shelf, lift the left part of the shelf
a bit, push itto the direction Q, lilt the right part
to the direction @,and take it out.
Lift the door rack holding both sides Q and
pull it out to @direction.
Lift the ice shelf as shown in the right figure
O and pull it out @.
Holdthe ice storage binas shown in the right
figureand pull it out @while slightly lilting it ®.
• It is recommended not to dismantle the ice
storage bin unless it is necessary.
• Use both hands to remove the icebin to avoid
dropping it.
• Ir the ice bin does not slideinto place easily,
twist the drive device slightly.
The water collector has no self-draining
function. It should be cleaned regularly.
Remove the cover by pulling the front side of
water collector cover and dry it with a cloth.
Drive
Device
To Next Page
Loading...
