3. Fan Shroud Grille
1) Loosen two screws after disconnecting a cap screw of a
grille fan (U) with a screwdriver balde.
2) Disassembly of a grille fan (U) : Pull forward after
opening hook at ➝ part with a screwdriver blade.
3) Disconnect housing A of a grille fan (L) from the main
body.
4) Disassembly of a grille fan (L) : Hold upper part of a
grille fan (L) and pull forward carefully.
5) Loosen two screws.
6) Disassembly of shroud. F (U) : Disconnect housing of B
after removing two rail guides with a screwdriver blade.
7) Disassembly of shroud. F (U) : Hold upper part and pull
forward.
8) Check foam sticking conditions around a shroud, F (U)
and F (L) during assembling. If damaged, torn, or badly
stuck, assemble with a new one after sealing well.
4. ICEMAKER ASSEMBLY
1. Dispenser Model
1) How to disassemble:
(1) Remove ice bin and shelf from the freezer
compartment.
(2) Loosen four screws under part of icemaker.
(3) Disconnect icemaker housing.
(4) Loosen a screw on the bracket and lift up the Ice
maker.
2) How to assemble:The assembly is the reverse order of
the above disassembly.
Note : When the ice tray is not horizontal after assembly,
assembly must be wrong. Check and assemble
again.
HOW TO DISASSEMBLE AND ASSEMBLE
- 105 -
To Next Page
Loading...
