2-15. Sequential operation of components
Electromechanical parts of the appliance, such as the compressor, defrost heater, freezer fan, cooling fan, and damper
motor, are operated sequentially as shown in the chart below to prevent noise and circuit overload from everything starting
at once.
MICOM FUNCTION
- 27 -
Function Load Operation Sequence Remark
In applying Initial power TEST MODE
When temperature
of a defrost sensor
becomes more
than 45°C
(initial setup,
movement)
If error occurs
during operation,
initial operation is
not done.
Sequence of load
operation when
closing freezer
and refrigerator.
The refrigerator
will return to
normal operation
if you press the
test switch once
again while in
Test Mode 2 or if
the temperature
of the defrost
sensor surpasses
41°F (5°C). The
compressor will
run after the 7-
minute delay.
When
temperature of a
defrost sensor
becomes less
than 45°C
(power failure,
service)
Test mode 1
(Compulsory
function)
Test mode 2
(Compulsory
defrost)
To Next Page
Loading...
