2) Indoor unit installation
The mounting wall should be strong and solid enough
to prevent it from the vibration.
1. Mount the installation plate on the wall with
four Type "A" screws.
• Always mount the installation plate horizontally by
aligning the marking-off line with using the thread
and a level.
LS-P0760CL/P0760HL, LS-P0820CL
LS-P0960CL/P0960HL
• To remove the installation plate, pull the two '¡ '
marked portion of bottom of chassis and pull the
installation plate out of chassis.
2. Drill the piping hole with 70mm dia. Hole-core
drill.
• Line according to the arrows marked on lower the
left and the right side of the installation plate.
The meeting point of the extended line is the center
of the hole.
• Drill the piping hole at either the right or the left and
the hole should be slightly slant to the outdoor side.
Left rear piping
ø70mm
ø70mm
50mm
20mm
20mm
80mm
LS-P0760CL/P0760HL, LS-P0820CL
LS-P0960CL/P0960HL
Right rear piping
WALL
5~7mm
Indoor Outdoor
LS-S0960CL/S0960HL, LS-S1120CL
LS-S1260CL/S1260HL, LS-S1420CL, LS-S1421CL
Left rear piping Right rear piping
Center Center
ø70mm ø70mm
To Next Page
Loading...
