2) Connection of pipings
(LS-S0960CL/S0960HL, LS-S1120CL, LS-S1260CL/S1260HL, LS-S1420CL, LS-S1421CL)
1. Remove the indoor tubing with Drain hose to the hole.
• Remove tubing holder and pull the tubing out of the chassis.
2. Refix the tubing holder into original position.
To remove the holder,
press the bottom of the
chassis near the holder
upwards and pull the tab
out of its hole.
For right rear piping
ƒ¡25ƒ¡
3. Route the tubing and the drain hose straight
backwards(see figure).
4. Insert the connecting cable into the indoor unit
through the piping hole.
• Do not connect the cable to the indoor unit.
• Make a small loop with the cable for easy connec-
tion later.
5. Tape the tubing, drain hose and the connecting
cable.
To Next Page
Loading...
