4
Safety PrecautionsOperating InstructionsCare and MaintenanceTroubleshooting Tips Care and Maintenance Operating Instructions Safety Precautions
Signal
receptor
Operation indication lamps
Preparation before operation
Storage and Tips For Using the Remote Control
• The remote control may be stored by mounting it
on a wall.
• To operate the room air conditioner, aim the
remote control at the signal receptor.
How to Insert the Batteries
Remove the battery cover by pulling it according to the
arrow direction.
Insert new batteries making sure that the (+) and (-) of
battery are installed correctly.
Reattach the cover by sliding it back into position.
NOTES:
• Use 2 AAA(1.5volt) batteries. Do not use rechargeable
batteries.
Signal Receptor
Receives the signals from the remote control.(Signal receiving sound: two short beeps or one long beep.)
Operation Indication Lamps
On/Off : Lights up during the system operation.
Sleep Mode : Lights up during Sleep Mode Auto operation.
Timer : Lights up during Timer operation.
Defrost Mode : Lights up during Defrost Mode or Hot
Start operation (Heat pump model only)
: Lights up during outdoor unit operation.
(Cooling model only)
: Indicates the setting temperature and the
operating frequency of compressor.(5 steps)
Plasma : The function illustrates its dynamic mode by using a multiple lighting system.
OUT
DOOR
OUTDOOR UNIT
OPERATION
Power Display
(Inverter only)
To Next Page
Loading...
Need help?
General
