Installation
NO. NAME OF PARTS Q'TY
1 FRAME CURTAIN 2
2 SILL SUPPORT 2
3 BOLT 2
4 NUT 2
5 SCREW (TYPE A) 13
6 SCREW (TYPE B) 3
7 SCREW (TYPE C) 5
8 FOAM-STRIP 1
9 DRAIN PIPE 1
10 FRAME GUIDE 2
11 WINDOW LOCKING BRACKET 1
12 FOAM-PE 1
SCREWDRIVER(Philips and Flatead), RULER, KNIFE, HAMMER, PENCIL, LEVEL ]
PREPARATION OF CHASSIS
Remove the screws which fasten the cabinet at both
sides and at the back.
@ Slide the unit from the cabinet by gripping the base pan
handle and pulling forward while bracing the cabinet,
Cut the window sash seal to the proper length.
Peel off the backing and attach the Foam-PE @ to the
underside of the window sash.
Shipping
wS
insertthe Frame Guides into the bottom of the
@
cabinet.
_) insertthe Frame Curtain Q into the Upper Guide and
Frame Guides @.
Fasten the curtains to the unit with 4
Type
A screws ®.
(TypeA)
[!,
Owner's Manual 13
To Next Page
Loading...
