15
EN
OPERATION
Control Panel and Remote Control
Control Panel Remote Control
NOTE
• The feature may be changed according to the type of model.
• On control panel surface have protection film, Please remove film before use.
Power
Press to turn the air conditioner ON or
OFF.
Operation Mode
Press the Mode button to cycle between 4
types of air conditioner operation: Energy
Saver / Cool / Dry / Fan.
Energy Saver - In this mode the compressor
and fan turn off when the set temperature
is achieved. Approximately every 3 minutes
the fan turns on to allow the unit sensor to
accurately determine if more cooling is needed.
Cool - This mode is ideal on hot days to cool
and dehumidify the room quickly. Use the
Temp buttons to set the desired room
temperature and use the Fan Speed button to
set the desired fan circulation speed.
Dry - This mode is ideal for rainy and damp
days to dehumidify the room rather than cooling
it significantly. Humidity is removed from
the room by the combination of compressor
operation and the fan speed fixed at Low.
The compressor and fan turn off once the set
temperature is reached. Fan speed cannot be
adjusted in Dry mode.
Fan - In this mode the fan circulates air but the
compressor does not run. Use the Fan Speed
button to set fan speed to High, Medium or
Low. In this mode, you cannot adjust the set
temperature.
NOTE
• In the Fan mode, all the 3 mode LEDs light
off and only the Fan Speed (F1, F2, F3) is
displayed.
Fan Speed
Press to set the Fan Speed to Low (F1),
Medium (F2) or High (F3).
Delay ON/OFF Timer
Delay ON - When the air conditioner is off,
set it to automatically turn on from 1 to 24
hours later, at its previous mode and fan
settings.
Delay OFF - When the air conditioner is
on, set it to automatically turn off from 1 to
24 hours later.
NOTE
• Each press of the Timer button
advances the timer by 1 hour. After
the last press the display returns to the
temperature setting.
To Next Page
Loading...
