11
Presetting the Radio Stations
You can preset 50 stations for FM and AM.
Before tuning, make sure that you have turned
down the volume to the minimum.
1.
Press TUNER on the front panel or
FUNCTION on the remote control to select the
frequency (AM or FM) you want.
2. Select a station you want by using AUTO
TUNING DOWN/ UP or MULTI JOG on the
front panel. Or press the TUN. (-/+) on the
remote control.
Tuning in automatically
- Press AUTO TUNING DOWN/ UP
on the
front panel. Or p
ress TUN. (-/+) on the
remote control
for more than 0.5 second.
Scanning stops when the unit tunes in a
station.
Tuning in manually
- Turn MULTI JOG
on the front panel
[
Or p
ress
TUN. (-/+) on the
remote control
]
briefly and repeatedly.
3. Press PROGRAM/ MEMO on the remote
control. Or PROG. MEMO. on the front
panel.
A preset number will flash in the display
window.
4. Press PRESET DOWN/ UP
[or PRESET/ FOLDER ( ) on the
remote control] to select the preset number
you want.
5.
Press PROGRAM/ MEMO or PROG. MEMO.
again.
The station is stored.
6.
Repeat the steps 1 - 5.
To delete all the memorized stations
Press and hold PROGRAM/ MEMO on the
remote control (or
PROG. MEMO.
on the front
panel) for about two seconds, “ERASE ALL”
appears in the display window. And then
PROGRAM/ MEMO on the remote control
(or
PROG. MEMO.
on the front panel) again, the
stations are deleted.
For your reference
If all stations have already been entered, “FULL”
message will appear in the display window for a
moment and then a preset number will flash. To
change the preset number, follow the steps 4-5.
To recall presets
Press and hold PRESET/ FOLDER ( ) on
the remote control until the desired preset num-
ber appears. Or press it repeatedly.
Listening to the Radio
1.
Press TUNER on the front panel or FUNC-
TION on the remote control to select the fre-
quency (AM or FM) you want.
The last received station is tuned in.
2. Press PRESET/ FOLDER ( ) on the
remote control repeatedly to select the preset
station you want.
- Each time you press the button, the unit
tunes in one preset station at a time.
3. Adjust the volume by rotating the VOLUME
control knob [or pressing VOLUME( )
on the remote control] repeatedly.
To listen to non-preset radio stations
• For manual tuning, see “Tuning in manually” in
the step 2 on the left.
• For automatic tuning, see “Tuning in automati-
cally” in the step 2 on the left.
To turn off the radio
Press
/
]]
(POWER) to turn the unit off or select
another function mode (CD, USB, AUX, A/V,
TAPE).
For your reference
•
If an FM program is noisy;
Press ST./MONO so that “MONO” appears in
the display window. There will be no stereo
effect, but the reception will be improved.
Press ST./MONO again to restore the stereo
effect.
•
To improve reception;
Reposition the supplied antennas.
Notes:
When receiving the MW (AM) broadcast, beat
noises may be occur. If it does, press AM-NOISE
button once.
AM -- NOISE ON ↔ AM -- NOISE OFF
To Next Page
Loading...
