Need help?Do you have a question about the LG MULTI F LMU18CHV and is the answer not in the manual?
General| Cooling Capacity | 18, 000 BTU/h |
|---|---|
| Heating Capacity | 20, 000 BTU/h |
| Refrigerant | R410A |
| Outdoor Unit Noise Level | 52 dB(A) |
| Type | Multi Split |
| Power Supply | 208/230V, 1 phase, 60Hz |
Defines symbols used throughout the manual for hazard identification.
Covers critical safety precautions for installing the unit, including warnings and cautions.
Details essential safety guidelines for electrical wiring and connections to prevent hazards.
Provides safety instructions for operating the unit, covering electrical shock, burns, and general precautions.
Presents detailed technical specifications for Multi F outdoor units, including capacities and dimensions.
Details technical specifications for Multi F MAX outdoor units, covering capacities, dimensions, and electrical data.
Provides specifications for Multi F MAX branch distribution units, including connectivity and dimensions.
Lists electrical data for Multi F outdoor units, including voltage, current, and power ratings.
Details electrical specifications for Multi F MAX outdoor units, covering power, current, and voltage requirements.
Explains the properties and safety considerations for using R410A refrigerant.
Guides on selecting the optimal location for the outdoor unit, considering safety and operational factors.
Covers considerations for rooftop installations, snow/ice planning, and lightning protection.
Specifies minimum clearances around the outdoor unit for proper airflow, service access, and obstacle avoidance.
Provides detailed instructions and safety warnings for rigging, lifting, and platform setup for the outdoor unit.
Outlines the necessary specifications and dimensions for outdoor unit foundation platforms.
Guides on selecting the best indoor location for Multi F MAX branch distribution units, considering accessibility and environment.
Provides instructions for installing Branch Distribution units, including ceiling and wall mount options.
Details procedures for preparing refrigerant piping, including cutting, flaring, and brazing practices.
Covers guidelines for selecting, handling, and maintaining piping materials to ensure system integrity.
Outlines limitations on connecting indoor units to outdoor units and branch distribution units.
Specifies maximum allowable lengths and elevation differences for refrigerant piping.
Details piping length and elevation limits specific to Multi F MAX outdoor unit systems.
Provides guidance on connecting Multi F outdoor units to indoor units, including pipe sizing and connection methods.
Explains how to connect Multi F MAX outdoor units to branch distribution units and indoor units.
Describes the process of flushing refrigerant piping with nitrogen gas to ensure cleanliness.
Details the steps for performing leak tests and vacuum procedures on the refrigerant system.
Provides step-by-step instructions for evacuating the refrigerant system to remove moisture and air.
Explains how to calculate and add the correct refrigerant charge based on piping length and system configuration.
Details requirements and methods for insulating refrigerant piping to prevent heat loss/gain and ensure system efficiency.
Covers general safety warnings and electrical requirements for wiring installations.
Guides on connecting power and communication cables to the outdoor unit, terminals, and other components.
Provides instructions for connecting power and communication cables to the BD unit for Multi F MAX systems.
Outlines the procedure for performing a test run to verify system operation and performance after installation.
Explains how to configure outdoor unit DIP switches for various operational modes and settings.
Covers using LGMV software and SIMs app for system monitoring, diagnostics, and troubleshooting.
Lists and explains error codes displayed by indoor and outdoor units for troubleshooting.
Addresses safety concerns related to refrigerant leaks and maximum allowable concentrations in occupied spaces.
Confirms proper installation of major components before final assembly and connection.
Ensures correct setup of condensate drainage systems for units.
Verifies correct installation and termination of electrical and communication wiring.
Checks proper installation and insulation of refrigerant piping.
Confirms adherence to recommended brazing procedures and safety.
Verifies correct installation of refrigerant piping, including lengths and connections.
Ensures correct installation of branch distribution units for Multi F MAX systems.
To Next Page