(6-1) Tighten the Sound Reflector. (Attached with magnet)
※ Check the DC Cable clearance before the Sound Reflector tightening. The Sound Reflector does not tighten properly if the DC Cable is protruding.
(6-2) Screw the Sound Reflector Fixation Screw(B) 2EA ※ Be careful not to scratch inside the stand when Sound reflector is assembled to Stand.
6-1
Sound Reflector
Sound Reflector
Reflector attached by magnet.
6-2
B
※Check the DC Cable before assemble Reflector to Stand.
Cable protrudes to the outside (NG)
Cable does not protrude
to the outside (OK)
OLED88ZX Assemble Guide
To Next Page
Loading...
