A-4
SETTING UP THE TV
Tidying cables
1 Install the Power Cord Holder and Power
Cord. It will help prevent the power cable from
being removed by accident.
(Only 42PN45**)
Power cord holder
(Only 50PN45**, 50/60PN65**)
Power cord holder
2 Gather and bind the cables with the Cable
Holder.
Cable holder
CAUTION
y
Do not move the TV by holding the cable
holder and power cable holder, as the cable
holders may break, and injuries and damage
to the TV may occur.
2
Protection
cover
M5 x 16
1 EA
CAUTION
y
When attaching the stand to the TV
set, place the screen facing down on a
cushioned table or flat surface to protect the
screen from scratches.
y
Make sure that the screws are inserted
correctly and fastened securely. If they are
not fastened securely enough, the TV may
tilt forward after being installed. Do not use
too much force and over tighten the screws;
otherwise screw may be damaged and not
tighten correctly.
NOTE
y
When installing the wall mounting bracket,
use the Protection Cover.
y
This will protect the opening from
accumulating dust and dirt.
y
Remove the stand before installing the TV
on a wall mount by performing the stand
attachment in reverse.
To Next Page
Loading...
Need help?
General
