To Next PageTo Next Page
Need help?Do you have a question about the LG PQRCVSL0 and is the answer not in the manual?
General| Brand | LG |
|---|---|
| Model | PQRCVSL0 |
| Category | Remote Control |
| Language | English |
Details the components and functions of the remote controller.
Instructions for connecting multiple units for group control.
Explains the procedure to enter the remote controller setup mode.
Guides on how to run the test run mode after installation.
Details on setting the address for central control connection.
Explains how to manually set wind strength for fan speed levels.
Function to select the temperature sensor for room temperature judgment.
Adjusts FAN Airflow rate based on ceiling height for ceiling type products.
Sets static pressure for duct type indoor units to prevent malfunction.
Function for settings in group control or 2-remote controller control.
Prevents indoor units from operating in cooling and heating mode simultaneously.
Enables dry contact function when equipment is separately purchased/setup.
Sets indoor unit's wind flow to variable or fixed.
Switches the display between Celsius and Fahrenheit.
Sets up a new zone or selects an old one to install the damper controller.
Sets the number of installed zones for control in zone new type.
Sets emergency heater operation for heating in emergency cases.
Sets features for indoor units with new installations or removed units.
Sets static pressure in 11 steps for duct type products.
Cools the room by providing comfortable and clean wind.
Adjusts desired temperature and checks current room temperature.
Cools the room quickly using pleasant and fresh air.
Removes humidity while performing slight air-cooling.
Supplies warm wind to the indoor unit.
Blows air without changing its temperature, circulating indoor air.
Operates the unit automatically based on Artificial Intelligence.
Adjusts desired wind powerfulness and direction.
Controls wind direction directly or indirectly via body perception sensor.
Cleans the air using plasma purification, available on humidifying models.
Adds humidity to the air, available on specific models.
Strengthens heating ability by turning on the electric heater during operation.
Improves comfort by slowly changing temperature for energy efficiency.
Automatically cleans the filter by the attached cleaner for specific periods.
Locks the keypad to prevent unwanted changes to settings.
Sets manual or automatic mode for smart cleaning.
Clears the indicator for indoor filter cleaning.
Moves the indoor filter up/down for cleaning the filter.
Adjusts the angle at which airflow is blown out.
Changes delta temperature for auto change over function.
Turns any set zones on or off.
Sets the current time and date for the remote controller.
Sets up or cancels the auto cleaning function.
Operates WLAN module in access point mode for specific models.
Sets reservation in 1-hour units, from 1 to 7 hours.
Runs and stops the unit after a set time during sleep mode.
Automatically turns the unit ON at a reserved time.
Automatically turns the unit OFF at a reserved time.
Sets daily reservations in weekly units, operating until cancelled.
Automatically stops the unit on reserved days.
Controls air conditioner and ventilation product simultaneously.
Interlinks air conditioner with general ventilation for cooling and refreshing.
Performs ventilation operation with cooling or heating using direct expansion product.
Operates ventilation more efficiently with fast or power saving settings.
Explains delay time operation for ventilation.
Sets reservations for ventilation operation during sleep.
Explains how to enter the installer setting mode for ventilation products.
Describes phenomena when indoor units have different drive modes.
Guides on checking items before consulting the service center.
Automatically retrieves operating conditions after power failure.
