To Next Page

To Previous Page

14 Indoor Unit

Installation Instructions

Installer Setting - Installer Setting Code Table

No. Function Function Code Setting Value Remote Controller LCD

0 Mode Override

0 : Set to Master

1 : Set to Slave

1 : Standard

2 : Low

3 : High

4 : Super High

0 : Set to Master

Group Control 1 : Set to Slave

2 : Check Master/Slave

3 :

Set to Auxiliary heater

Auxiliary heater 4 :

Cancel Auxiliary heater

2 :

Check Auxiliary heater Installation

Installer Setting Code Table

Ceiling Height

Selection

Mode Override

This Function is only for Non-Auto Changeover H/P model.

Ceiling Height Selection

Indoor unit connected to wired remote controller operate as wired remote controller setting.

Group Control

This function is only for group control. Please don’t set this function in case of non-group control.

After setting Group Control of the product, turn off the power then turn it back on after 1 minute.

Auxiliary heater

This function is only applied to models with Auxiliary Heater function being activated.

LG PREMTBB01 Owner's Manual

Other manuals for LG PREMTBB01