20
Caring for Your Dryer
■ Ventilation Grill and Cool Air
Inlet Grill
Vacuum the front ventilation grill 3-4 times a
year to make sure there is no build up of lint
or dirt that may cause improper air flow.
NOTE
- Warm air is exhausted through the
ventilation grill.
- Adequate ventilation should be
provided to avoid the back flow of
gases into the room from units
burning other fuels, such as open
fires.
1. Take
connecting
kit out.
■ Condensed Water Drain-out
Normally, condensed water is pumped up to
the water container where water is collected
until manually emptied. Water can also be
drained out directly to a mains drain,
especially when the dryer is stacked on top
of a washing machine.
With a connecting kit for the mains drain
hose, simply change the water path and
re-route to the drainage facility as below:
■ Moisture Sensor
The device senses the moisture level of the
laundry during operation, which means it
must be cleaned regularly to remove any
build-up of lime scale on the surface of the
sensor.
Wipe the sensors inside drum. (as
illustrated)
3. Connect
drain hose
to the kit.
2. Separate
water
container
hose from
the kit.
To Next Page
Loading...
Need help?
General
